|Home||» Products||» Induction Bearing Heater||» 38 ESD Induction Bearing Heater|
— The heater works by inducing a (low frequency) current in the component to be heated. This is achieved by incorporating the component as a secondary winding in a transformer. The primary winding is connected to the mains power by means of an electronic control. The magnetic field induces a high current (short circuit current) through the component which consequently becomes hot. The work piece is automatically demagnetised after every heating cycle.
BETEX 38 ESD microprocessor controlled bearing induction heater, Three phase 400/500 V, 50 Hz, 8.0 Kva with the unique Betex swing arm construction, and supports for horizontal heating.
YOKE 30, 70 mm, max. temperature 240°C, digital display, incl. magnetic probe, automatic demagnetization, better than 2A/cm, time or temperature pre selection, acoustic signal at the end of each heating cycle , provided with audio alarm in reaching set temperature, temperature hold, incl. service kit and CE-manual,
TECHNICAL SPECIFICATION :